T O P I C R E V I E W |
vnwagoncam |
Posted - 23 Mar 2012 : 05:27:21 AM Hi, The diff is about to go in the 3.8 V6, I am looking for a whole rear axle 2nd hand because its just not worth the cost of a diff overhaul and I want to know if the VR - VS rear axle will fit into the VN. Also its a stationwagon but I already found out that the mounts are different on wagons... If I could look for a VR - VS one it would make life easier.. |
4 L A T E S T R E P L I E S (Newest First) |
thedunga |
Posted - 24 Mar 2012 : 9:18:37 PM oh yeah and the dunga is a series 1 vn wagon |
thedunga |
Posted - 24 Mar 2012 : 9:14:17 PM actually the dunga has a vr diff in it and the soft line block on vr/vs is different it wont take the vn soft line end and the vr/vs soft line block wont fit the vn hard lines on the diff so swapping all the lines on the diff will be needed other than that it is straight forward |
Mechknight73 |
Posted - 23 Mar 2012 : 6:55:48 PM Just be sure to take the cover plate off the back of the diff (be ready with a new gasket) and have a look inside before fitting it. Check your driveshaft all the way along. I'm not saying you haven't checked it, but you might be replacing the wrong part if you haven't.
|
vnwagoncam |
Posted - 23 Mar 2012 : 5:20:53 PM ok if anyone else wants to know... The VN through to VS are all the same. Stationwagon is compatible with ute but sedan is different. I got one out of a VS , hope its good |