| T O P I C R E V I E W |
| suswpn |
Posted - 03 Jun 2012 : 12:47:21 PM
just recently replaced the engine, car tries to start but wont fire
its getting fuel to the rail but no fuel into the cylinders has spark fuel pump is fine, im stumped :( anyone had this problem before ? |
| 14 L A T E S T R E P L I E S (Newest First) |
| suswpn |
Posted - 07 Jun 2012 : 10:23:58 AM
so now the car is starting, as soon as you give the car a little throttle it sorta missfires and trys to die :( |
| VNSVLE |
Posted - 04 Jun 2012 : 02:15:38 AM
Excellent news buddy!! |
| suswpn |
Posted - 03 Jun 2012 : 10:38:55 PM
sweet, il do that tomorow. now i gotta put the tail shaft in and finish the car so i can drive it again ! |
| VNGRPA |
Posted - 03 Jun 2012 : 10:22:37 PM
that would just be the tps on it mate just change it over with a v6 one and the light will go off, glade you got it all sorted |
| suswpn |
Posted - 03 Jun 2012 : 10:19:20 PM
got it working, i got a mate to plug the wiring loom into the computer and one of the little white plugs got hidden behind abit of plastic i got under and sussed out the loom and noticed a plug was missing, fired up thanks christ! haha thanks for the help.
also since i have a 5 litre throttle body, my engine light is always on ? |
| VNSVLE |
Posted - 03 Jun 2012 : 8:37:30 PM
Yep over at Squaredarches as well buddy.
Crank angle sensor should throw a code which means your engine check light will be on.
Code 41 I think.
Check your EFI relay and injector wiring just to make sure there is not something you forgot to connect.
Cheers |
| VNGRPA |
Posted - 03 Jun 2012 : 4:58:25 PM
try that mate |
| VNGRPA |
Posted - 03 Jun 2012 : 4:57:14 PM
http://www.vncommodore.com/forum/topic.asp?TOPIC_ID=450 |
| suswpn |
Posted - 03 Jun 2012 : 3:50:56 PM
how do i go about that?
|
| VNGRPA |
Posted - 03 Jun 2012 : 2:53:07 PM
try doing a code check first mate it might save you a bit of time |
| suswpn |
Posted - 03 Jun 2012 : 2:50:45 PM
yeah sweet, i still have my old motor sitting there so i might take the cas off and put it on this one and see if that fixes the problem |
| VNGRPA |
Posted - 03 Jun 2012 : 1:49:22 PM
sounds like a CAS problem if your getting fuel and its just not kicking over, VNSVLE knows heaps about these motors mate so your in good hands, |
| suswpn |
Posted - 03 Jun 2012 : 1:47:48 PM
nah mate, are you also on squared arches? iv only just dropped the motor in and bolted it up put oils etc in and tried firing it and nothing just trys to start fuel is going through the rail but the injectors arnt pulsing so fuel is getting into the cylinders. |
| VNSVLE |
Posted - 03 Jun 2012 : 1:38:37 PM
Welcome to the club buddy!!
Have you had it running since the new engine has been in?? |
