recently i purchased a pair of vp berlina brake lights, apon installing them it was evident that they where not entirely water proof, i was wondering if anyone had any tips on removing the lenses without damaging them
did you make sure the rubber seals on the back of them were ok a good thing to do is get some silicon sealant and put some on both sides of the seal as this is usually where the water comes though
you can take lenses off, however some are siliconed togeather and some are glued/siliconed togeather which u cannot seperate without breaking
best thing to do is get a stanly knife and a hairdryer, can also use a heat gun but u run the risk of melting the plastic
slowly peel away the silicon and cut if need be while useing the hair dryer to sofen up the silicon, all while very carefull seperating the lense from the reflector, it takes time so have patiance and you should be sweet:)
Topic Locked
| Join the Forum to Rate this Topic at: 
Posted - 14 Dec 2009 : 7:35:18 PM
